+#define USB_QUIRK_DELAY_CLOSE 0x0040 / Delay close / #define USB_QUIRK_VENDOR_CLASS 0x0020 / Descriptor uses vendor-specific and are protected by Federal -103,6 +103,7 USB_QUIRK_USB_INIT 0x0010 /* Needs vendor USB init string / These coded instructions, statements, and computer programs are the.
#HP LASERJET 1300 PRINTING PROBLEMS CODE#
+++ backend/usb-libusb.c (working -3,7 +3,7 LIBUSB interface code for CUPS. +0x03f0 0x1d17 delay-close Index: backend/usb-libusb.c unidir Only supported unidirectional -227,3 +228,13 All Intermec devices (STR #4553) soft-reset Do a soft reset after printing for cleanup. +# delay-close Delay close/reset of selected interface no-reattach Do no re-attach usblp kernel module after printing. +++ backend/-quirks (working -5,6 +5,7 product ID (omit for all vendor products), and a list of known issues: blacklist The printer is not functional with the USB backend. If necessary, replace the damaged system fan."str4549.patch": Index: backend/-quirks
#HP LASERJET 1300 PRINTING PROBLEMS PC#
This may enable you to use the computer long enough to store your data to an external hard drive before the laptop shuts down again. Suppose you ever have problems with a PC build or have questions about where to go next. Restart your computer to check if the error still occurs. Remove any dust that may harm the cooling fan. Clean the exterior vents of your laptop.To solve HP system fan error 90b, follow these steps: If HP error 90b orrucs, the laptop usually shuts down within 15 seconds. It is not recommended to continue using the laptop, because the cooling fan is not working properly, which could lead to an accidental shutdown and the loss of your data. Both error codes indicate that there is a problem with the HP laptop system fan. HP error 90b or error 90f occurs while starting the HP laptop. Check in the listener.log file for an event.If an easy connect naming connect identifier was used, prove that the service name specified is a service known to the listener.Dopple-check that the SERVICE_NAME parameter in the connect descriptor of the net service name used specifies a service known to the listener.Find out which services are currently known by the listener by executing: lsnrctl services.This can be a temporary condition, for example, after the listener has been started, but before the database instance has registered with the listener. Either it has not been dynamically registered with the listener yet or has not been configured statically for the listener. The connect descriptor that has been received by the listener specified a service name for a service (usually a database service).
The listener received a request to set up a connection to a database or other service.